Current best sellers

Tikkurila Fontecryl PP Primer for Powder Coating

New product

A waterborne, single pack fast drying acrylic based primer containing active anti-corrosion pigments. Recommended for use as a primer under powder coatings for steel.

Matt Finish

Available in Grey

Pack size 20 litre

More details

£317.66

- +

 
Product Info

A waterborne, single pack fast drying acrylic based primer containing active anti-corrosion pigments. Recommended for use as a primer under powder coatings for steel.

Matt Finish

Available in Grey

Pack size 20 litre

Especially suitable for dipping.

Drying times can be shortened by using higher temperatures.

Overcoatable with a wide range of products, including  solventborne products. 

Preparation
Surfaces to be coated must be clean, dry and free from any material such as oil, grease, salts and dirt that might affect adhesion.
Remove loose flaking or friable material. 
Where necessary, remove weld spatter and grind smooth all rough,sharp edges and weld seams.

Galvanised steel
Thoroughly degrease with Cleaner Degreaser (Product Reference H30 or ND14) and lightly abrade any very shiny areas. 

Mild Steel 
Degrease with a Cleaner Degreaser (Product Reference H30 or ND14) and either manually abrade or blast clean to Sa2½ (ISO 8501-1:2007)
If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion.

Phosphate Steel 
Degrease with Cleaner Degreaser (Product Reference H30 or ND14) and manually abrade prior to application of the Primer Coat

Stainless Steel
Degrease with Cleaner Degreaser (Product Reference H30 or ND14) and manually abrade. 

Aluminium and Alloys
Degrease with Cleaner Degreaser (Product Reference H30 or ND14) and manually abrade. 

The temperature of the ambient air, surface or paint should not fall below 5ºC during application or drying.

Application Conditions
Relative humidity should not exceed 80%. 
The surface temperature of the steel should remain at least 3ºC above the dew point.
Cold damp conditions will impair drying times and the final finish.

Recommended Finish Coats
Overcoat with powder coating and Fontecryl finishes

Recommended Thinners 
Water

Coverage Rates
Recommended Film weight:Minimum WFT 45µm Maximum 90µm
Theoretical coverage rate: 11.3-22.7m² per litre

Application Methods
Tikkurila Fontecryl PP Primer can be applied by the following methods.

Airless Spray: Yes
Conventional Spray: Yes
Brush: Yes 
Roller: Yes

Application Guidance 
Airless Spray
Thinning with water up to 10% (Note thinning will reduce the film weight)

Brush / Roller 
Recommended for small areas and touch up. Thin as appropriate to achieve a smooth film flow.

Please note: application by brush and roller will result in a reduced film thickness and is recommended only for small areas of touch up/remedial work

Drying times at a WFT at 90µm and 23ºC 
Dust Dry: 20 min 
Recoatable: 30 min
Through Dry: 24h 

Cleaning Tools and Equipment
Clean equipment with 1737 Thinner after use

% Volume Solids : 33-35%
VOC content : 22-24g / litre

Safe use
This product is formulated for professional use. 
Please ensure suitable and appropriate personal protective equipment is worn during handling and application.

For more detail please consult the Product Datasheet.
Please contact us for the Health and Safety Datasheet.

30 other products in the same category:

Menu

Top
Compare 0