Top sellers

New

10L, Tikkurila Temalac AB 70

New product

A highly durable single pack, glossy alkyd metal topcoat for site application to bridges storage tanks exteriors and structural steelwork.

Gloss finish

More details

£0.00

- +

 
Product Info

A highly durable single pack, glossy alkyd metal topcoat for site application to bridges storage tanks exteriors and structural steelwork.

Gloss finish

Preparation

Surfaces to be coated must be clean, dry and free from any material such as oil, grease, salts and dirt that might affect adhesion.
Remove loose flaking or friable material. 
Where necessary, remove weld spatter and grind smooth all rough,sharp edges and weld seams.

Galvanised steel
Thoroughly degrease with Cleaner Degreaser (Product Reference H30 or ND14) and lightly abrade any very shiny areas. 

Mild Steel 
Degrease with a Cleaner Degreaser (Product Reference H30 or ND14) and either manually abrade or blast clean to Sa2½ (ISO 8501-1:2007)
If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion.

Phosphate Steel 
Degrease with Cleaner Degreaser (Product Reference H30 or ND14) and manually abrade prior to application of the Primer Coat

Stainless Steel
Degrease with Cleaner Degreaser (Product Reference H30 or ND14) and manually abrade. 

Aluminium and Alloys
Degrease with Cleaner Degreaser (Product Reference H30 or ND14) and manually abrade. 

The temperature of the ambient air, surface or paint should not fall below 5ºC during application or drying.

Application Conditions
Relative humidity should not exceed 80%. 
The surface temperature of the steel should remain at least 3ºC above the dew point.
Cold damp conditions will impair drying times and the final finish.

Recommended Finish Coats
Overcoat with Temalac finishes

Recommended Thinners 
1006 or 1054 (slow) Thinners

Coverage Rates
Recommended Film weight:Minimum WFT 80µm Maximum 115µm
Theoretical coverage rate: 8.7-13.0m² per litre

Application Methods
Tikkurila Temalac FD finishes can be applied by the following methods.

Airless Spray: Yes
Conventional Spray: Yes
Brush: Yes 
Roller: Yes

Application Guidance 

Airless Spray
Output fluid pressure at tip 1700-2600psi, 
Tip Size 11-15 thou 
Thinning with  1006 (Note thinning will reduce the film weight)

Brush / Roller 
Recommended for small areas and touch up. Thin as appropriate to achieve a smooth film flow.

Please note: application by brush and roller will result in a reduced film thickness and is recommended only for small areas of touch up/remedial work

Drying times at a WFT at 100µm and 23ºC 
Dust Dry: 3h 
Recoatable: 24h

Cleaning Tools and Equipment
Clean equipment with 1006 or 1054 Thinner after use

% Volume Solids : 51-53%
VOC content : 400-496g / litre

Safe use
This product is formulated for professional use. 
Please ensure suitable and appropriate personal protective equipment is worn during handling and application.

For more detail please consult the Product Datasheet.
Please contact us for the Health and Safety Datasheet.

Accessories

30 other products in the same category:

Menu

Top
Compare 0