Top sellers

New

Teamac Anti-Slip Suregrip Deck paint

New product

Teamac Suregrip is a safety coating for use inside and outside where a sure foothold is required. For foot or light truck traffic. Can be used on wood, metal, concrete, GRP and other suitably prepared surfaces.

Available in 6 colours.

Apply by brush or roller.

More details

£38.48

- +

Brand: Teamac

 
Product Info

Teamac Suregrip is a safety coating for use inside and outside where a sure foothold is required. For foot or light truck traffic. It is ideal for application on wood, metal, concrete, GRP and other suitably prepared surfaces.

It is ready for use and contains special coarse aggregates which dry to provide a rough bonded surface which is both durable and decorative.

Surface Preparation

Remove all loose and damaged existing coating and all marine growth. High pressure wash with fresh water. Areas of breakdown should be blasted or power tool cleaned. Touch up with Teamac Metaclor Primer to the full existing film thickness. Prior to the application of the full coat ensure that surface is clean and free of all contaminates.

On aluminium, ideally abrade the surface to provide a "key", clean, then immediately coat with Metaclor Primer. When dry apply 2nd coat. If abrasion is not possible, the surface must be degreased and treated with 'T' Wash/Mordant solution (leave to react for 2 hours), follow the instructions on the pack. When this is clean and dry apply the 2 coats of Metacote Primer, 

On exposed metal and wood.Prime first with at least 2 coats of Teamac Metacote Primer (but not more than 3). 

On GRP lightly abrade exposed surfaces and apply 2 coats of Teamac Metacote Primer. 

New steel: Abrasive blast clean to Sa2½ and apply Teamac Metacote Primer. 
If applying onto shop-primed steel ensure that surface is dry and clean, and areas of damaged primer are suitably cleaned prior to the application of Metacote Primer.


Application Method: Brush or roller 
Thinning; Do not thin

Theoretical Spreading Rate: 6-10m2 / litre @ 100-150 microns WFT

The practical spreading rate may be lower as this depends on factors such as the porosity and roughness of the surface to be painted and material losses during application.

Drying times @ 100-150 microns WFT
Touch Dry 6 hours @ 20 °C
Hard Dry 24 hours @ 20 °C

Volume Solids: 58-62%

30 other products in the same category:

Menu

Top
Compare 0